Signs you may need to repipe
These patterns point to pipes at the end of their life.
Repeated leaks
A second or third pinhole leak in a short time suggests the pipe wall is thinning everywhere.
Rusty or discolored water
Brown water from hot and cold taps, especially after sitting, can mean corroding steel pipe.
Falling pressure
Mineral buildup inside galvanized pipe narrows the opening and reduces flow.
Known problem pipe
Galvanized steel and polybutylene are materials plumbers often recommend replacing.
Frequent freeze splits
Pipes in exterior walls that split repeatedly may need rerouting along with replacement.
Visible corrosion
Green or white crust at joints and fittings is a sign of failing connections.
PEX or copper
Both are used in homes. Each has trade-offs.
| Feature | PEX | Copper |
|---|---|---|
| Installation | Flexible, fewer joints, faster | Rigid, soldered joints, slower |
| Freeze tolerance | Expands more before splitting | Rigid, more likely to split |
| Cost | Usually lower material and labor | Usually higher |
| Lifespan | Long, but not exposed to sunlight | Long track record |
| Water taste | Neutral for most people | Neutral in most cases |
How a repiping project goes
Repiping is disruptive but manageable with a plan.
Assess and plan
We inspect the existing pipe, map the routes and discuss which fixtures to prioritize.
Open and replace
We make small access openings in walls and ceilings and run new lines, often with a manifold for PEX.
Connect and test
We connect fixtures and pressure test the new system before closing access.
Patch and clean
We restore access holes or coordinate with a drywall contractor, and clean up the site.
Pipes failing again?
Call (385) 488-1892 and tell us what you are seeing. We will tell you whether repiping makes sense.
Permits and inspections
A repipe changes the plumbing system, so a permit is typically involved. Call the Building Division at 801-489-2704 and ask what applies to your address. The city schedules inspections through its City Inspect portal with 24 hours of notice, and required inspections include rough plumbing.
Springville's basement guide also notes that plumbing within 1 1/4 inches of the stud face needs nail plates, a detail that matters when new lines run through older framing.
Planning around a repipe
Repiping touches every room with a fixture, so planning matters. We walk the house with you, agree where access holes will go and decide the order of rooms so you can keep a working bathroom as long as possible.
Ask who handles drywall patching and paint. Many plumbers leave patching to a separate trade, and we tell you up front what is and is not included so you can schedule the rest. Pets, children and anyone with medical needs deserve a plan for the days when water is off.
What affects the cost of repiping
Prices vary with house size and access.
Call (385) 488-1892 for your price.
Before you commit
Get the diagnosis first. A leak detection visit, described on our leak detection page, shows whether leaks are isolated. If the answer is a single failed section, a spot fix may do. See burst pipe repair for emergency repairs.
Springville's Water Division at 801-489-2740 can test or advise on your incoming pressure, since high pressure shortens the life of any pipe.
Code and permit note
Code note: replacement piping must use materials approved under the International Plumbing Code (IPC), which is one reason we name the pipe type in the quote.
Common questions
It depends on the size of the house and the access. Many homes take a few days. We give a schedule before starting.
We plan the work to keep outages short and tell you in advance when water will be off.
PEX is approved for potable water use. We install pipe that meets applicable standards.
Not necessarily right away, but galvanized pipe corrodes from the inside and eventually fails. We help you plan.
Yes. We dispatch to Mapleton, Spanish Fork, Salem and Provo.
