Disposal emergency: jammed, smoking or leaking
Treat these three as urgent. Each can damage the kitchen or put someone at risk.
Jammed and humming
Switch it off at the wall switch and unplug it or turn off the breaker. Never reach into the chamber. A plumber can free the flywheel safely.
Leaking under the sink
Water at the bottom of the unit often means a failed seal and the unit must be replaced. A leak at the sink flange or drain line can be repaired.
Smoke or burning smell
Cut power at the breaker and do not run it again. A burned motor is not repairable.
Backing up into the sink
If the sink fills when the disposal runs, the clog is likely in the drain line beyond it. Stop and call.
Disposal problems and fixes
Most disposal faults follow a few patterns.
| Problem | Usual cause | Fix |
|---|---|---|
| Hums but will not spin | Jammed flywheel from a spoon, bone or fruit pit | Free the jam from below, test the unit |
| Does not turn on or hum | Tripped reset button, bad switch or burnt motor | Reset, test the switch, replace unit if burned |
| Leaks from the bottom | Failed internal seal | Replace the unit |
| Leaks at the top | Loose or worn sink flange gasket | Reseat the flange with new putty and gasket |
| Slow draining sink | Partial clog beyond the disposal | Clear the drain line |
Disposal jammed or leaking?
Call the 24/7 line. We will tell you what is safe to try and what to leave alone.
Repair or replace a disposal
Disposals are relatively simple machines, but a failed motor or seal makes replacement the practical choice.
Repair when
- A jam can be cleared
- The leak is from a flange or a drain connection
- The unit is fairly new
- The motor runs and the grinding is quiet
Replace when
- The unit leaks from the body
- The motor is burned out
- The unit is old and noisy
- You want a larger horsepower or a quieter model
Double sinks, dishwashers and the right setup
A disposal on a double kitchen sink usually shares a drain line with the second basin and the dishwasher. The dishwasher drain hose connects to the disposal inlet or to an air gap, and the knockout plug in a new disposal must be removed or the dishwasher will not drain.
These details cause many repeat calls after a do it yourself swap. A correct installation also keeps the trap and the vent in good order. Related work like faucet repair and drain cleaning often comes up at the same visit.
What to keep out of the disposal
Grease, coffee grounds in volume, fibrous peels, pasta and rice are the usual causes of slow kitchen lines. Grease solidifies farther down the pipe where the disposal cannot reach, and it builds over months. Cold water while grinding and a few seconds of flushing afterward help.
Springville's municipal code covers what can go into the city's systems, and the Building Division at 801-489-2704 can answer code questions about a kitchen remodel. For anything that already clogged, cable cleaning clears it.
What affects the cost
A repair is usually quicker and cheaper than a new unit, and we say which fits before starting.
Call (385) 488-1892 for your price.
Code and permit note
Code note: the International Plumbing Code (IPC) treats the dishwasher drain connection and trap arrangement as part of a correct sink drain.
Common questions
Yes. Our line is open around the clock. If the unit is leaking or smoking, switch off power, turn off the water under the sink and call.
The flywheel is jammed. Switch off power and have a plumber free it, or use the hex socket at the bottom only with power fully off. Do not use your hand.
Yes. We connect the dishwasher drain correctly and make sure both basins drain freely.
It varies with use and what goes in. If yours leaks from the body or the motor burns out, replacement is the answer.
Yes. We dispatch to Mapleton, Spanish Fork, Salem and Provo.
